Kubota K008-5, Operating Instructions Manual

Page: 157 / 168

Lifting capacity of the excavator
W9215-8135-1
155
06/2021
LIFTING CAPACITY OF THE EXCAVATOR
Constructive calculation of lifting capacity

The lifting capacity of the excavator is based on ISO 10567 and does not exceed 75% of the static tipping
load or 87% of the hydraulic lifting capacity of the machine.

The lifting capacity is measured at the front bolt of the arm with the arm fully extended. The arm is fully in the
dump position. The boom cylinder is the operating cylinder.

The lifting conditions are:

As well as the lifting conditions, the length of the arm also affects the permitted lifting capacities and the sta-
bility of the machine. Compare the dimensions of the machine arm with the details given in the lifting capacity
tables, in order to use the correct lifting capacity table for your machine.
1. Swivel up to 360° The position of the dozer is not relevant to the maxi-
mum lifting capacity when swivelling up to 360°.
The illustration on the label is representative of both
states: Dozer up and down.
2. Over front end, dozer down
3. Over front end, dozer up
Dimensions for the arm, see "Arm version" table in the "Dimensions" section (page 42).
Do not lift loads which exceed the values indicated in the lifting capacity tables.
The values given in the tables apply only to level and hard grounds. When working on soft ground,
the machine can tip over easily, as the load is concentrated on one side only and the track or the
dozer can dig into the ground.
The values given in the tables apply only for loads without bucket. If a bucket is used, the weight of
the bucket must be subtracted from the values in the tables. The weight of mounted accessories (e.g.
breaker) must be subtracted from the lifting capacity.
Always observe the maximum permissible lifting capacity of the hoisting gear (e.g. load hooks). The
lifting of loads over the maximum permissible lifting capacity is not allowed.
During lifting operations, the boom may not be swivelled to the left or right. The machine could tilt!
To avoid accidental operation, fold down the rear part of the boom swing pedal.
During lifting operations, driving/moving the crawler chassis is not permitted.
STOP
STOP
STOP
STOP
STOP
STOP