Kubota GR1600EC2, Workshop Manual, Page: 209 / 241

6-S10
GR1600EC2, WSM ELECTRICAL SYSTEM
(3) Starter
Motor Test
CAUTION
• Secure the starter to prevent it from jumping up and down
while testing the motor.
1. Disconnect the battery negative cable from the battery.
2. Disconnect the battery positive cable and the leads from the
starter.
3. Remove the starter from the engine.
4. Disconnect the connecting lead (2) from the starter C terminal
(1).
5. Connect a jumper lead from the connecting lead (2) to the battery
positive terminal post.
6. Connect a jumper lead momentarily between the starter motor
housing and the battery negative terminal post.
7. If the motor does not run, check the motor.
W10142670
Starter Magnet Switch Test (Pull-in, Holding Coils)
NOTE
■
• Preparate a 6 V battery for the test, and each test should be
carried out for 3 to 5 seconds.
1) Checking Pull-in Coil
1. Connect jumper lead from the battery's negative terminal post to
the C terminal.
2. The plunger should be attracted strongly when a jumper lead is
connected from the battery positive terminal to the S terminal.
2) Checking Holding Coil
1. Connect jumper leads from the battery's negative terminal post to
the body and the battery's positive terminal post to the S terminal.
2. Push the plunger in by hand and release it. Then, the plunger
should remain being attracted.
W1015210
(1) C Terminal (2) Connecting Lead
KiSC issued 07, 2006 A