Kubota GR1600EC2, Workshop Manual, Page: 142 / 241

2-S13
GR1600EC2, WSM TRANSAXLE
PTO Rod Spring
1. Remove the two nuts (2) (3) and spring (4).
(When reassembling)
1. Assemble a fuel tank, a seat base and a fender.
2. Setting the PTO lever at “Disengaged” position and lifting the
PTO arm (5) slightly by hands directly, the upper side of PTO arm
(5) and lower nut (6) on the upper side of PTO rod (1) make
contact, and there is no play between them. Keeping this
position, be sure to tighten the two nuts (6) (7) on the upper side
of this PTO rod (1).
3. Assembly temporarily the spring (4) and two nuts (2) (3) to the
PTO rod (1). After this, set the PTO lever at “Engaged” position,
and then be sure to tighten two nuts (2) (3) on the lower side of
PTO rod (1) so that the spring length (L2) reaches the specified
value.
(When reassembling)
IMPORTANT
■
• After completing above assembling / adjustment, repeat the
motion several times to set the PTO lever at “Disengaged”
and “Engaged” position. Then, finally set the PTO lever at
“Engaged” position. Be sure to check that the upper side of
PTO arm (5) and the lower sides of two nuts (6) (7) on the
upper side of PTO rod (1) are making no contact.
(Reference)
• Length (L1) : 115 to 118 mm (4.53 to 4.64 in.)
• Length (L3) : 38 to 40 mm (1.50 to 1.57 in.)
W1014341
Spring length (L2) Factory spec.
68 mm
2.68 in.
(1) PTO Rod
(2) Nut
(3) Nut
(4) Spring
(5) PTO Arm (6) Nut
(7) Nut
(A) “Disengaged” Position
(B) “Engaged” Position
KiSC issued 07, 2006 A