CAB INSTALLATION
14 of 29
STEP 14: (REMOVABLE REAR PANEL)
For Premium Cab only.
If installing a standard cab, proceed to step 15 below.
14.1
Before installing the rear panel, lift the pop
-
up roof
by pressing up on the yellow lever on the quick release
latches. It may help to pull down slightly on the grab
handles while releasing the latches.
14.2
Lift rear panel and insert the upper pins into the
receivers on the rear legs. Engage the lower quick
release latches at this time. See Fig. 14.2.
Note: The quick release latches require (2) clicks to be
fully locked. Press the rear panel in from the outside in
these locations to double click the latches.
Fig. 14.2 (rear panel installation)
Fig. 15.1 (rear curtain installed)
snaps
Pin / Receiver
Quick release latch
Fig. 15.2a (rear curtain
-
left side of cab)
apply velcro
here
Fig. 15.2b (rear curtain
-
right side of cab)
apply velcro
here
STEP 15: (REAR CURTAIN)
For Standard Cab only.
If installing a premium cab, proceed to step 16 below.
15.
1 Before installing rear curtain, make sure roof is
down. Snap the supplied rear curtain to the outside of
the rear panel header. See Fig. 15.1.
15.2
Using the supplied Velcro, secure the sides of the
rear curtain and bottom edge to the sideframes and
fenders, respectively. See Fig. 15.2a and 15.2b.
STEP 16: (TIGHTEN ALL FASTENERS)
16.1
Re
-
check all previously installed fasteners to
ensure that they have been properly tightened.
