KTM Freeride 350 2017 Series, Setup Instructions

Page: 8 / 26

2 SETUP
6
B01995-10
–
Insert the black and violet cables of the bulb included in the separate enclosure
into the socket and position it in the turn signal indicator lamp
 .
–
Position the turn signal on each side and mount and tighten nuts

.
–
Connect the plug-in connector

of the right turn signal with the connector
marked green on the wiring harness.
–
Connect plug-in connector

of the left turn signal with the connector marked red
on the wiring harness.
–
Mount turn signal relay  with the retaining bracket and plug in the connector.
–
Mount the handlebar cushion.
–
Install the front fender. ( p. 16)
–
Refit the headlight mask with the headlight. ( p. 16)
M00695-01
–
Mount the footrests with the springs and pins. Secure the pins using the washers
and cotter pins.
Pliers for footrest spring (79029083000)
B01170-01
–
Mount the license plate holder with the license plate lamp, turn signals, and reflec-
tor.
–
Connect the electrical components.
–
Connect the plug-in connector of the right turn signal with the connector marked
green on the wiring harness.
–
Connect the plug-in connector of the left turn signal with the connector marked red
on the wiring harness.
B01173-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. ( p. 13)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts fitting instructions.