KTM Freeride 350 2017 Series, Setup Instructions

Page: 5 / 26

2 SETUP
3
2.1 Unpacking and setting up the vehicle
M00075-10
Package 2
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
–
Remove the separate enclosure and unpack it. Check that the scope of supply
is complete on the basis of the enclosed packing list.
–
Have a lift stand available.
Lift stand (78929955100)
–
Carefully loosen and remove the tension belt of the footrest mount.
Info
An assistant prevents the motorcycle from falling over.
402050-01
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
M00075-11
Package 12
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
–
Remove and unpack the separate enclosure and attachments. Check that the
scope of supply is complete on the basis of the enclosed packing list.
–
Have a lift stand available.
Lift stand (78929955100)
–
Remove the two cable ties on the triple clamp.
402051-01
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a lift stand.
–
Check the vehicle and attachments for transport damage.
–
Install the shock absorber. ( p. 8)
B01163-01
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp M8 22 Nm
(16.2 lbf ft)
Screw, bottom triple clamp M8 18 Nm
(13.3 lbf ft)