KTM Freeride 350 2017 Series, Setup Instructions

Page: 7 / 26

2 SETUP
5
B01991-10
–
Mount the connector retainer and speedometer on the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position turn signal indicator lamp  .
–
Connect all plug-in connectors to the connector retainer.
B01992-10
–
Remove the fuel tank. ( p. 10)
–
Pull the EFI control unit from the holder and set it to one side.
–
Take off the electrical compartment.
–
Disconnect the plug-in connector on the main wiring harness.
–
Connect the plug-in connector of the turn signal wiring harness with the plug-in
connector of the main wiring harness.
B01176-01
–
Position the turn signal wiring harness against the main wiring harness and secure
with cable ties.
Info
The routing of the wiring harness is shown in the figure.
–
Mount the electrical compartment.
–
Position the EFI control unit.
–
Install the fuel tank. ( p. 11)
402148-01
–
Mount the turn signal switch and connect the plug-in connector on the wiring har-
ness.