KTM Freeride 350 2017 Series, Setup Instructions

Page: 6 / 26

2 SETUP
4
Info
Position the bleeder screws toward the front.
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
M01029-11
–
Remove screws

. Take off the handlebar clamps.
–
Remove screws

. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws
 .
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
B01164-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
–
Install the front wheel. ( p. 9)
M00543-01
–
Position the controls on the right half of the handlebar.
M00544-01
–
Position the controls on the left half of the handlebar.