13 SERVICE WORK ON THE CHASSIS
100
E02247-10
Main work
–
Loosen nut
1
.
–
Loosen nuts
2
.
–
Adjust the chain tension by turning adjusting screws
3
left
and right.
Guideline
The chain tension is correctly set when the screwdriver is
parallel to the ground.
Turn adjusting screws
3
on the left and right so that the
markings on left and right chain tension adjusters
4
are in
the same position relative to reference marks
A
. The rear
wheel is then correctly aligned.
Info
The top part of the chain must be taut.
Chain wear is not always even, so you should check the
setting at different chain positions.
–
Tighten nuts
2
.
–
Make sure that chain adjusters
4
are fitted correctly on
adjusting screws
3
.
–
Tighten nut
1
.
Guideline
Nut, rear wheel
spindle
M25x1.5
90 Nm (66.4 lbf ft)
Thread greased
Info
Chain adjusters
4
can be turned by 180°.
Finishing work
–
Remove the vehicle from the center stand. (
13.11
Checking the chain, rear sprocket, and engine sprocket
Preparatory work
–
Raise the vehicle with the center stand. (
100132-10
Main work
–
Check the chain, rear sprocket and front sprocket for wear.
» If the chain, rear sprocket or front sprocket is worn:
–
Change the drivetrain kit.
Info
The front sprocket, rear sprocket and chain
should always be replaced together.
