3
WORK
7
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Remove the battery. (
100151-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid
.
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing
.
–
Switch off and disconnect the charger after charging.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Install the battery. (
–
Mount the seat. (
–
Set the clock. (
3.4
Removing the battery
Warning
Risk of injury
Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
B01974-10
Main work
–
Remove battery cover
.
–
Pull the EFI control unit
off of the holder and set it to one side.
