3
WORK
8
B01975-10
–
Disconnect negative cable
of the battery.
–
Take off the positive terminal cover
and disconnect the positive cable from the
battery.
–
Remove screws
.
–
Pull retaining bracket
of the battery forward and remove it.
–
Lift the battery up and out.
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components and safety devices can be damaged.
The vehicle is therefore no longer roadworthy.
3.5
Installing the battery
B01975-11
Main work
–
Insert the battery into the battery compartment with the terminals facing rearward.
Battery (YTZ10S)
–
Position retaining bracket
and mount and tighten screws
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Position the positive cable and mount and tighten the screw.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Position positive terminal cover
.
–
Position negative cable
and mount and tighten the screw.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
B01976-10
–
Position EFI control unit
.
–
Mount battery cover
.
Finishing work
–
Mount the seat. (
–
Set the clock. (
3.6
Opening the filler cap
Danger
Fire hazard
Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning
Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Store fuel properly in a suitable canister and keep away from children.