MAINTENANCE WORK ON CHASSIS AND ENGINE
49
9.39
Checking the play in the throttle cable
400192-10
–
Move the handlebar to the straight-ahead position. Move the throttle grip back-
wards and forwards to ascertain the play in the throttle cable.
Play in throttle cable
3… 5 mm (0.12… 0.2 in)
» If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
x
(
p. 49)
Danger
Danger of poisoning
Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
» If the idle speed changes:
–
Adjust the play in the throttle cable.
x
(
p. 49)
9.40
Adjusting the play in the throttle cable
x
–
Remove the fuel tank.
x
(
p. 70)
–
Check throttle cable route. (
p. 48)
500153-10
–
Move the handlebar to the straight-ahead position.
–
Push back bellows
.
–
Loosen nut
. Turn adjusting screw
in as far as possible.
–
Loosen nut
. Turn adjusting screw
so that there is play in the gas throttle
cable at the throttle grip.
Guideline
Play in throttle cable
3… 5 mm (0.12… 0.2 in)
–
Tighten nut
.
–
Press and hold the throttle grip in the closed setting. Turn adjusting screw
out
until there is no play in the throttle cable
.
–
Tighten nut
.
–
Push bellows
on. Check the throttle grip for smooth operation.
–
Install the fuel tank.
x
(
p. 71)
–
Check the play in the throttle cable. (
p. 49)
9.41
Checking for chain dirt accumulation
400678-01
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. (
p. 50)
Summary of Contents for 450 XC-W SIX DAYS USA 2010
Page 2: ......
Page 103: ...101...
Page 106: ...WIRING DIAGRAM 104 ye Yellow ye bl Yellow black ye re Yellow red...
Page 107: ...WIRING DIAGRAM 105...
