KTM 350 EXC-F 2017, Owner'S Manual

Page: 108 / 129

19 CLEANING, CARE
106
19.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
–
Close off the exhaust system to keep water from entering.
–
Remove coarse dirt particles with a gentle water jet.
–
Spray dirty parts with a normal commercial engine cleaner and then brush off with
a soft brush.
Motorcycle cleaner ( p. 119)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle
with water first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the brake system.
–
Brake carefully several times to dry out and remove dirt from the brake
linings and the brake discs.
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and
on the brake system to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. ( p. 66)
–
Treat bare metal (except for brake discs and the exhaust system) with a corrosion
inhibitor.
Preserving materials for paints, metal and rubber ( p. 119)
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
( p. 119)
–
Grease steering lock.
Universal oil spray ( p. 119)
–
Grease the ignition switch.
Universal oil spray ( p. 119)