KTM 2013 450 Rally Factory Replica, Owner'S Manual

Page: 92 / 126

19 STORAGE
90
19.1 Storage
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Info
If you want to garage the motorcycle for a longer period, take the following actions.
Before storing the motorcycle, check all parts for function and wear. If service, repairs or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at the
start of the new season.
401058-01
–
Clean the motorcycle. ( p. 88)
–
Change the engine oil and oil filter, clean the oil screen.
x
( p. 84)
–
Check the antifreeze and coolant level. ( p. 77)
–
Add fuel additive the last time you refuel before taking the motorcycle out of
service.
Fuel additive ( p. 118)
–
Drain the fuel from the fuel tanks into a suitable container.
–
Empty the carburetor float chamber.
x
( p. 82)
–
Check the tire air pressure. ( p. 71)
–
Remove the battery.
x
( p. 73)
–
Recharge the battery.
x
( p. 73)
Guideline
Storage temperature of battery without
direct sunshine 0… 35 °C (32… 95 °F)
Charging level of the battery for storage 50… 75 %
–
Place the vehicle on a dry storage place that is not subject to large temperature
variations.
Info
KTM recommends raising the motorcycle.
–
Raise the motorcycle with the lift stand. ( p. 40)
–
Cover the vehicle with an air-permeable cover or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Because the engine will not
warm up sufficiently, the water vapor produced during combustion will con-
dense, causing engine parts and the exhaust system to rust.
19.2 Preparing for use after storage
401059-01
–
Remove the motorcycle from the lift stand. ( p. 40)
–
Install the battery.
x
( p. 73)
–
Fill up with fuel. ( p. 29)
–
Perform checks and maintenance steps when preparing for use. ( p. 26)
–
Take a test ride.