10
TUNING THE CHASSIS
38
10.16
Handlebar position
400361-10
On the upper triple clamp, there are 2 holes at a distance
A
to each other.
Distance
A
between holes
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
B
from the center.
Distance
B
between holes
3.5 mm (0.138 in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can
be installed in the position most comfortable for the rider.
The handlebar supports can also be mounted at 2 different heights (with and without
spacer).
Spacer height
9 mm (0.35 in)
10.17
Adjusting the handlebar position
x
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0
0
3
3
0
0
2
2
0
0
1
1
0
0
4
4
0
0
5
5
0
0
6
6
0
0
7
7
0
0
8
8
0
0
9
9
400343-10
–
Remove the four screws
1
. Remove handlebar clamps
2
with rubber washers
3
and elastomers
4
.
–
Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the lower shells
5
.
–
Take out clamp bar
7
with the rubber cones
6
.
–
Remove the two screws
9
. Remove the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten the two
screws
9
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Condition
Spacer
8
mounted:
Use a M10x35 screw
Condition
Without a spacer
8
:
Use a M10x25 screw
Info
Position the left and right handlebar supports evenly.
–
Insert rubber cones
6
and clamp bar
7
.
