KTM 1190 RC8 AUS, Owner'S Manual, Page: 150 / 250

MAINTENANCE WORK ON FRAME AND ENGINE
148
100724-10
–
Remove spacer

. Clean and grease the mating surfaces of the spacers and the shaft
seal rings.
Long-life grease ( p. 239)
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing. x
–
Install the spacer.
–
Clean the thread of the axle and nut.
–
Clean the mating surfaces of the brake caliper frame and swingarm.
100725-10
–
Push the brake caliper frame

completely to the rear.
–
Position the rear wheel, and place the brake caliper frame between the rim and the
brake disc.
–
Slide the brake caliper onto the brake disc.
–
Position the rear wheel on the mating surfaces in the swingarm.