36
SMARTRONIC MA
VIII - 3 - 2 - 3 ”HART setpoint” directory
--
HART position Setpoint:
Position setpoint as a % if product is operating in HART mode (read/write)
VIII - 3 - 3 ”Diagnosis” directory
VIII - 3 - 3 - 1 ”Number of operations” directory
--
Number of operation
: Number of opening/closing cycles (read only, but can be reset)
VIII - 3 - 3 - 2 ”Run time” directory
Total run time (read only)
--
Days:
Number of days operation since the 1st time the product was started
--
Hours:
Number of hours operation since the 1st time the product was started
--
Minutes:
Number of minutes operation since the 1st time the product was started
Run time since reset (read only)
--
Days:
Number of days operation since the last reset
--
Hours:
Number of hours operation since the last reset
--
Minutes:
Number of minutes operation since the last reset
VIII - 3 - 4 ”Settings” directory
VIII - 3 - 4 - 1 ”Regulator” directory
--
Autocalibration status
Autocalibration procedure step (read only:
- End - Standby
- Working ...: Auto-calibration in progress.
--
Auto-calibration
Function to start the autocalibration procedure (write only).
HART communication is no longer possible during autocalibration.
--
Positioner status :
Positioner calibration status (read only)
- Run
- Calibration Run
- Calibration Done
- Calibration Fail
- Calibration change rotation direction
- Calibration Start
- Calibration Pause
- Calibration Stop
- Calibration Abort
- Calibration Fail: hardware
- Calibration Fail: regulator