▪
Observe the minimum flow rates indicated in the product literature (to prevent
overheating, bearing damage, etc.).
▪
Observe the maximum flow rates indicated in the product literature (to prevent
overheating, mechanical seal damage, cavitation damage, bearing damage, etc.).
▪
Do not throttle the flow rate on the suction side of the pressure booster system
(to prevent cavitation damage).
▪
Consult the manufacturer about any use or mode of operation not described in
the product literature.
Prevention of foreseeable misuse
▪
Never exceed the permissible operating limits specified in the product literature
regarding pressure, temperature, etc..
▪
Observe all safety information and instructions in this manual.
2.1.3 Personnel qualification and training
All personnel involved must be fully qualified to install, operate, maintain and
inspect the machinery this manual refers to.
The responsibilities, competence and supervision of all personnel involved in
installation, operation, maintenance and inspection must be clearly defined by the
operator.
Deficits in knowledge must be rectified by sufficiently trained specialist personnel
training and instructing the personnel who will carry out the respective tasks. If
required, the operator can commission the manufacturer/supplier to train the
personnel.
Training on the pressure booster system must always be supervised by technical
specialist personnel.
2.1.4 Consequences and risks caused by non-compliance with these operating
instructions
▪
Non-compliance with these operating instructions will lead to forfeiture of any
and all rights to claims for damages.
▪
Non-compliance can, for example, have the following consequences:
– Hazards to persons due to electrical, thermal, mechanical and chemical
effects and explosions
– Failure of important product functions
– Failure of prescribed maintenance and servicing practices
– Hazard to the environment due to leakage of hazardous substances
2.1.5 Safety awareness
In addition to the safety instructions contained in this manual and the intended use,
the following safety instructions shall be complied with:
▪
Accident prevention, health and safety regulations
▪
Explosion protection regulations
▪
Safety regulations for handling hazardous substances
▪
Applicable standards and laws
2.1.6 Safety information for the operator/user
▪
The operator shall fit contact guards for hot, cold and moving parts and check
that the guards function properly.
▪
Never remove a contact guard while the pump is running.
▪
Eliminate all electrical hazards.
2 Safety
8 of 56
Hya®-Solo DV
