▪
Tripping current 0.5 to 3 mA
(equivalent to a tripping resistance of 3 to 60 k
Ω)
5.4.2
Electrical connection
DANGER
Electrical connection work by unqualified personnel
Danger of death from electric shock!
▷
Always have the electrical connections installed by a trained electrician.
▷
Observe IEC 60364 regulations as well as any locally applicable regulations.
WARNING
Incorrect connection to the mains
Damage to the mains network, short circuit!
▷
Observe the technical specifications of the local energy supply companies.
CAUTION
Improper routing of power cable
Damage to the power cables!
▷
Never move the power cables at temperatures below -13 °F [-25 °C].
▷
Never kink or crush the power cables.
▷
Never lift the submersible mixer by its power cable.
CAUTION
Motor overload
Damage to the motor!
▷
Protect the motor by a thermal time-lag overload protection device in
accordance with IEC 947 and local regulations.
Observe the wiring diagrams and function diagrams of the relevant motor sizes when
connecting the motor. (
⇨
Section 9.3 Page 49)
The submersible mixer is supplied with a power cable. Always connect all marked
cores.
DANGER
Operating an incompletely connected submersible mixer
Explosion hazard!
▷
Never start up a submersible mixer with incompletely connected power cables
or non-operational monitoring devices.
DANGER
Incorrect connection
Explosion hazard!
▷
The connection point of the cable ends must be located outside hazardous
areas or in an area approved for electrical equipment.
CAUTION
Flow-induced motion
Damage to the power cable!
▷
Run the power cable upwards without slack.
5 Installation at Site
Amamix
21 of 54
