The manufacturer is not liable for persons and/or damage to property, which can be attributed to incorrect
utilization of the device!
5. Technical data
6. Application
6.1 Switching on/Utilization
ATTENTION:
The battery booster must be charged for a minimum of 72 hours prior to first utilization! The first
charging must be carried out with the supplied automatic network-charging device!
Check, by operating the red pressure switch on the front of the device the charge condition of the battery. A minimum
of one green bar must illuminate on the coloured bar display on the lower part of the display. So that all possible
damages to the Booster are avoided it must be noted that the Booster is not completely discharged!
Information when connecting to a 12/24 Volt vehicle battery
ATTENTION:
Prior to connecting the Booster to any vehicle which on-board voltage is present and if there is more
than one battery if a series or parallel switching exists. Always check the manufacturers guidelines prior
to jump-starting the vehicle!
Characteristics
550.1710
550.1720
Voltage
12 V
12/24 V
Selector switch
Nein
12 - off - 24 V
Cranking Amps CA
700 A
1400 / 700A
Peak Amps
2200 A
4400 / 2200A
Battery
1x22Ah sealed lead acid battery
2x22Ah sealed lead acid battery
Battery lifetime
approximately 600 cycles
approximately 600 cycles
Charge control display
Digital Voltmeter by at the touch of a
button
Digital Voltmeter by at the touch of a
button
Charging time
up to 6 h
bis zu 12 h
Scope of utilization
Car/transporter
Otto and Diesel (up to max.2,5 L)
Car/transporter/ NFZ
Otto and Diesel
Charging device
Automatic network charging device
Automatic network charging device
Charge voltage
230V~50HZ
230V~50HZ
Charge current
12V - 4000mA
12V-4000mA
weight
approximately 10 kg
approximately 18 kg
Other characteristics
Incorrect connection protection
optical and acoustic
optical and acoustic
Safety switching
Current flow only after clamping
Current flow only after clamping
Protection against power surges
Yes
Yes
Housing
Pb with rubberised base area
Pb with rubberised base area
IP Protection classes
Automatic charging device
IP 20
IP 20
Booster
IP 20
IP 20
Cable length
1600 mm
1600 mm
Cable storage
on the sides of the housing
on the sides of the housing
Cable cross section
35 mm²
35 mm²
High performance copper clamps
Yes
Yes
Clamps
complete insulation up to 1000 A /
L=190mm
complete insulation up to 1000 A /
L=190mm
Start attempts when fully charged
max. 20
max. 20
