Krone Titan 6/50 GL, Operating Instructions Manual, Page: 102 / 134

VII - 12
Maintenance
7.11 Lubrication
7.11.1 Special safety instructions
• Maintenance, care, service and cleaning work must only be carried out when the machine
is shut down. Shut down the engine, remove the ignition key and switch off the electrical
supply at the control box.
• Secure the tractor and loading wagon from rolling away.
• After care and maintenance work is finished, re-install all protective covers and protective
devices in the correct manner.
• Avoid getting oils and greases on the skin.
• In case of injury due to escaping oil, immediately call a doctor.
7.11.2 General information
7.11.3 Articulated shaft
The lubrication intervals for the articulated shaft are
shown in the figure on the right. For further information,
see the articulated shaft manufacturer’s operating
instruction.
Definition of terms
Term Lubricant Point/Quantity Special features
Greases Multipurpose grease Lubrication nipple/ Remove excess grease from
approx. two pumps of the lubrication nipple
grease gun
Lubrication If no other stipulated, Sliding surfaces/spread Remove old and excess
use vegetable-based oils thinly with a brush oil
Oils If no other stipulated Chains Spread evenly on
use vegetable-based oils the chain
The maintenance intervals are based on an average work load for the short-cut loading wagon. The intervals must
be shortened for greater work loads and extreme working conditions.
KLW10340
40h 40h
8h 8h 8h
20h
8h