Start-up
51
Pos : 23.27 /Ü bersc hriften/Ü berschrif ten 2/F-J /G elenkwelle montier en @ 2\ mod_1202398342788_78.doc x @ 59253 @ 2 @ 1
7.5
Install the PTO shaft
Pos : 23.28 / BA/Sic herheit/ Gel enkwell e/G ef ahr - Sic h drehende G el enkwelle_2 @ 0\ mod_1199781692950_78. doc x @ 34523 @ @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
•
Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
•
Secure the tractor against rolling.
•
Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
•
Make sure that the protective devices are attached properly.
•
Never use a PTO shaft, the protective devices of which have not been attached.
•
Replace damaged protective devices immediately
•
Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos : 23.29 / BA/Sic herheit/ Gel enkwell e/G ef ahr - Antri ebs dr ehz ahl 540 beac ht en @ 3\ mod_1205316518245_78.doc x @ 73595 @ @ 1
Danger! -
Observe drive speed
Effect: Danger to life or serious injuries
•
This machine is driven at a maximum PTO speed of 540 rpm.
Pos : 23.30 / BA/I nbetri ebnahme/ Sc hwader /Anbau G el enkwelle/Anbau Gel enkwelle angehängt e Schwader Bild @ 2\ mod_1202398077960_78.doc x @ 59233 @ @ 1
5
4
2
SW9070008
3
6
1
3
1
Figure 26
Pos : 23.31 / BA/I nbetri ebnahme/ Sc hwader /Anbau G el enkwelle/Anbau Gel enkwelle angehängt e Schwader Text @ 37\ mod_1263463772393_78.doc x @ 339645 @ @ 1
•
Switch off the engine and remove the ignition key.
•
Install the PTO shaft (1) on the machine side (wide angle on machine side).
•
Rotate the PTO shaft support (2) upwards.
•
Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin
is securely engaged.
•
Secure the PTO shaft guard against turning with the retaining chain (3).
Pos : 23.32 / BA/I nbetri ebnahme/ Sc hwader /Masc hi ne anheben U nt erlenkeranhängung @ 2\ mod_1203505446705_78. doc x @ 66344 @ @ 1
Lifting the machine
•
Lift machine slightly.
•
Rotate the parking supports (4) 90° downwards and with the support (5) in this position
lock it and secure with spring cotter spring.
Pos : 24 /BA/---------------Seitenumbruc h---------------- @ 0\ mod_1196175311226_0. doc x @ 4165 @ @ 1
