EN
page 35
OFF
DRAIN THE SUMP
2.6
Emptying boiler and break tank (anti-freeze function)
This function permits the draining of the boiler and the break tank for any extraordinary
maintenance or emptying function.
• Press key “B” (Stand By) and make sure that the tank is empty.
• Press the "A" (Start) button for 3 seconds and the boiler e break tank draining will activate.
The message “Boiler draining" will appear on the display and the "A" (Start) button will
flash in blue light. Should the wash-tank be full, the system will not start the draining
phase of the boiler and the display will show “Drain the wash-tank!”.
• Once emptying is complete, the machine can be turned back on with key “B” (ON), but
is frozen until the tension is removed and replaced
by the general wall switch.
WARNINGS:
• Do not slam the door when opening and closing.
• Do not put material or objects on the machine.
• The machine has an IPX
4
protection rating against accidental water splashes and is not
protected against pressurized water jets. Pressure-cleaning systems shall, therefore, not
be used on this machine.
•
Do not dip bare hands into water containing detergent. If this should occur, wash
them immediately with plenty of water. Check the safety instructions on the detergent
container.
• Some important rules must be followed for using this appliance:
1) never touch the appliance with wet hands or feet;
2) never use the appliance when barefooted;
3) do not install the appliance in places exposed to water splashes.
•
This machine must be disconnected from the main electrical supply after use at
the end of the day and for any service/maintenance operation. Switch off the main
switch located on the wall, which shall be installed by a professional installer. Shut
the water supply valve(s).
• Do not cover the intake or dissipation grids.
• Do not use water to extinguish fires on electrical parts.
WARNING: INTERNAL CLEANING OF THE MACHINE SHALL BE CARRIED OUT AT
LEAST 10 MINUTES AFTER THE POWER SWITCH HAS BEEN TURNED OFF.
WARNING: DO NOT INSERT HANDS AND/OR TOUCH THE PARTS LOCATED AT THE
BOTTOM OF THE WASH TANK AND/OR AT THE END OF THE WASH CYCLE.
ON
After the draining is complete, the machine will turn automatically in
"STAND-BY"
mode.
If you want to refill the machine for a new cycle, see chap. 2.2.
DRAIN THE WASHTANK
Summary of Contents for KP202E
Page 4: ......
