7
Glue two steering wheel box parts 80 together
and onto the right rear wall of the cabin onto the hole.
Glue door 82 to its marking of bulkhead 6.
Bend an eyelet 78 and a cleat 79 from 1,0mm brass wire.
Drill 1,0 and 2,0mm holes into the flag mast 75 in the correct distance for the size of the flag.
Now glue cleat and eyelet into the flag mast.
Fix the flag to the flag mast.
Drill a 4,0 mm hole at the position you wish into the deck for the flag mast.
Slide the flag mast 75 through plate 76 and glue both to the deck.
Glue fendering bar 84 to the sides of the hull, about 14 mm higher but parallel to the waterline.
Now you can varnish all wooden areas several times with filler and sand between each layer.
Paint your model now with colours of your own choice.
Be sure that all electronic parts, motor, coupling and linkage is covered before you spray.
Placing of window glazing
It is important, that the covering foil remains on the window glazing until the windows are glued in and the
glue is set. Take the windows out of the laser sheet and stick them into the painted window cut outs. Now
fill the gap from both sides with Tacky glue with your finger. When the windows are fixed well by the glue
you can tear off the covering foil.
Glue the position lamps 85 onto the lamp boards. You can place in coloured lamps before, left side red,
right side green.
Glue top light 86 onto its support 71. The rear light 86 will be glued onto the deck centred behind the wall
of the back seat.
Mount the brass nut 88 onto the prop shaft and the prop 87. Fix the nut against the prop, that it cannot
loosen when running backwards.
Place the bigger name plate to the stern of the hull. The two smaller name plates can be fixed at sides of
the bow. Paint them with clear varnish before.
84
