Basic Operation of the S-1200/ 1200U Cont...
41
S-1200/ 1200U
4. Tape / VCR inputs and outputs
The TAPE and VCR inputs and outputs are specifically provided to allow recording and playback of
analog audio and video sources. When the Tape or VCR input is selected, the Tape or VCR outputs
are shuts off so as not to allow feedback. The Tape or VCR inputs will accept the analog audio or
video signals from any active and selected device.
5. Button Mode presets
The S-1200/ 1200U front panel has a row of buttons for quick access to Surround decoding modes.
The Modes Are:
A.
Pre Amp - Direct analog connection with no processing of the incoming signal.
B.
Stereo - Default mode for PCM digital input or 2-channel analog audio with processing.
C.
Mode 1 - Default mode as defined in the decode method preference. (P28, C)
D.
Mode 2 - Direct access to all available decode modes.
E.
Prologic - Direct access to the available Dolby Prologic Modes.
6. Save and Recall
The configuration parameters and settings defined in the set-up menu can be saved to a default
layout. Once a layout has been saved it can be recalled at anytime restoring back to the last saved
working presets.
To Save a layout:
Press and Hold the
Save
button on the Front panel. The front panel display will show “Saving
Setup” and return to its last activity.
To Recall a layout:
Press and Hold the
Recall
button on the Front panel. The front panel display will show “Recall
Setup”, the Initialization splash screen will pop up and the unit will go into Stand-by. Press the
Power button, the last saved version of the layout will now be active.
7. Factory reset
The S-1200/ 1200U has a full factory reset sequence, this will adjust all settings and parameters
back to the original factory specification. To activate a factory reset:
While the unit is powered on and in the operation state, press and HOLD the Recall button on the
front panel, and while holding the
Recall
button press the
Power
button on the front panel and
then release.
The front panel display on the S-1200/ 1200U will go black, the unit will turn off, and about 2
seconds later the unit will re-initialize displaying current firmware version number. All of the settings
are now back to the factory defaults.
