11
Be aware of the hazards that could reduce the performance of your equipment, and therefore the user’s safety, if exposed to extreme
temperatures (< -30°C or > 50°C), prolonged exposure to the elements (UV rays, humidity), chemical agents, electrical constraints, twisting
of the fall arrest system during use, sharp edges, friction or cutting, etc.
Before using, always check
that the locking system is in working order and that the fall indicator is not triggered (if there is one on the
connector). Check that the cable/webbing is not cut, frayed or burnt. Check that the metal parts are not deformed or oxidised, and check that
the connectors are working properly (locking/opening). The protective casings and the cover of the energy dissipater must be in place and
undamaged. Product markings must remain legible. If there is any doubt as to the condition of the device, or after a fall, it must not be reused
(marking it with the words «DO NOT USE» is recommended) and must be returned to the manufacturer or to a qualified person appointed
by the manufacturer.
Do not remove, add or replace any component of the product.
Chemical products: put the system out of use if it is exposed to chemical products, solvents or fuels which could affect its working.
TECHNICAL DATA: Webbing 20 mm – Material: polyester and polyamide – Breaking strength > 15 kN
SUITABILITY FOR USE:
The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363) to guarantee that the dynamic force
exerted on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body gripping device that may be used.
It may be dangerous to create one’s own fall arrest system where each safety function can interfere with another safety function. Therefore,
it is important to read the recommendations on using each component in the system before use.
VERIFICATION PROCEDURE:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized
by KRATOS SAFETY), but it may be increased or reduced according to use and/or the results of the annual inspections. The equipment
should be inspected if there is any doubt, or following a fall and at least annually, by the manufacturer or a competent person authorised by
the manufacturer to check its strength and hence the user’s safety. The product’s factsheet must be completed (in writing) after each check;
the inspection date and the date of the next inspection must be indicated on the factsheet, it is also advisable to specify the date of the next
inspection on the product.
SERVICING AND STORAGE:
(these instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and in its packaging. Clean with water, wipe with a cloth and hang
in a ventilated room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may
have got wet during use. The device must be stored in a cool, dry and ventilated room, and in its packaging.
Summary of Contents for Olympe-S2 FA 20 502 02
Page 48: ...48 NOTES ...
