Kramer Electronics Ltd.
VS-6464DN-EM
– Using the Configuration Menus
29
Config Menu
—
Setting Output Port Parameters
This option sets port-specific parameters. Ports that show an
X
have no parameters available
to modify. Ports that show an
o
have parameters available to modify. The parameters that are
available, such as, audio balance, depend on the type of card installed and whether the card
is an input or an output card. Tables listing output cards and their parameters can be found at
the end of this section.
To set parameters for a port:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENTER to change them
2. Press MENU until a display is shown similar to the following:
OUT: 01 02 03 04 05 06 07 08 09 10 11
SET: o
o
X
X
o
o
o
o
X
X
X
X
indicates that there are no modifiable parameters for the associated port and
o
indicates
that there are modifiable parameters for the associated port.
3. Press TAKE to enter the list of ports.
The cursor flashes on a selected port.
4. Select the required port to modify using the left and right arrow buttons.
5. Press TAKE to enter the parameters list.
A message similar to the following is displayed with the relevant port number in place of
06:
OUT: 06
SET: Reset SubBoard
6. To select the next parameter press the right arrow button (see
Or:
7. To enter the displayed parameter press TAKE.
The parameter options are displayed.
8. Select the required action or number using the keypad numbers and arrows.
9. Press TAKE to save the change.
The parameter change is not implemented on the system until you press TAKE.
10. Repeat from Step 6 to modify other parameters.
11. Do one of the following:
▪
Press BREAKAWAY to exit the Config Menu.
▪
Wait approximately 15 seconds for the operation to time out.
▪
Press MENU to exit to the parameter list.