![background image](http://html.mh-extra.com/html/kramer/vs-6464dn-em/vs-6464dn-em_user-manual_2001399029.webp)
Kramer Electronics Ltd.
VS-6464DN-EM
– Using the Configuration Menus
27
Config Menu
—
Input Signal Detection Display
This option displays a list of inputs and indicates on which of them signals have been
detected.
To display a list of inputs that have detected signals:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENTER to change them
2. Press MENU.
The following is displayed:
IN:
01 02 03 04 05 06 07 08 09 10 11
OUT: o
X
o
o
o
o
X
o
o
o
X
o
indicates that a signal is detected and
X
indicates that no signal is detected on the
relevant input.
3. Do one of the following:
▪
Press BREAKAWAY to exit the Config Menu.
▪
Wait approximately 15 seconds for the operation to time out.
▪
Press MENU to move to the next Config Menu option.
Config Menu
—
Setting Input Port Parameters
This option sets input port-specific parameters. Ports that show an
X
have no parameters
available to modify. Ports that show an
o
have parameters available to modify. The
parameters that are available, such as, audio balance, depend on the type of card installed
and whether the card is an input or an output card (see
Using the Input / Output Cards
for information on the input / output cards and their parameters).
To set parameters for a port:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENTER to change them
2. Press MENU until a display is shown similar to the following:
IN:
01 02 03 04 05 06 07 08 09 10 11
SET: X
X
X
X
o
o
X
X
o
o
X
X
indicates that there are no modifiable parameters for the associated port and
o
indicates
that there are modifiable parameters for the associated port.
3. Press TAKE to enter the list of ports.
The cursor flashes on a selected port.
4. Select the required port using the left and right arrow buttons.