Kramer Electronics Ltd.
VS-62H
– Connecting the VS-62H 6x2 HDMI Matrix Switcher
9
Connecting a Serial Controller to the VS-62H via RS-
232
To connect a serial controller to the
VS-62H
:
From the RS-232 9-pin D-sub serial port on the serial controller connect:
•
Pin 2 to the TX pin on the
VS-62H
RS-232 terminal block.
•
Pin 3 to the RX pin on the
VS-62H
RS-232 terminal block.
•
Pin 5 to the GND pin on the
VS-62H
RS-232 terminal block.
Connecting to the VS-62H via Ethernet
You can connect to the
VS-62H
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting the Ethernet Port Directly to
).
•
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port via a Network Hub
).
Note
: If you want to connect via a router and your IT system is based on IPv6, speak to your
IT department for specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VS-62H
directly to the Ethernet port on your PC
using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VS-62H
with the factory configured default IP address.
After connecting the
VS-62H
to the Ethernet port, configure your PC as follows
:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.
The Local Area Connection Properties window for the selected network adapter appears
as shown in