18
VS-48HN - Operating the VS-48HN 4x8 HDMI Matrix Switcher
6.8
Connecting via RS-232
You can connect to the
VS-48HN
via an RS-232 connection using, for example, a
PC. Note that a null-modem adapter/connection is not required.
To connect to the product via RS-232:
Connect the RS-232 9-pin D-sub on the rear panel of the
VS-48HN
via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5
need to be connected) to the RS-232 9-pin D-sub port on your PC
6.9
Connecting via Ethernet
You can connect to the
VS-48HN
via Ethernet using either of the following methods:
Directly to the PC using a crossover cable (see
Section
6.9.1
)
Via a network hub, switch, or router, using a straight-through cable (see
Section
6.9.2
)
After connecting the
VS-48HN
to the Ethernet port, configure your local Ethernet
port by following the instructions in the
Kramer Ethernet Configuration User Guide
available from
http://www.kramerelectronics.com/support/product_downloads.asp
.
Note
: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.9.1
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VS-48HN
directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VS-48HN
with the factory configured default IP address.
6.9.2
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the
VS-48HN
to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
6.10
Upgrading the Firmware
For instructions on upgrading the firmware see “
Upgrading the
VS-48HN
Firmware
Using the STC Software
”.
i