![background image](http://html.mh-extra.com/html/kramer/vs-42hdcp/vs-42hdcp_user-manual_2001338020.webp)
VS-42HDCP - Controlling the VS-42HDCP
17
17
7.2.1
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VS-42HDCP
directly to the Ethernet port
on your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VS-42HDCP
with the factory configured default IP address.
7.2.2
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the
VS-42HDCP
to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
7.3
Using the IR Transmitter
You can use the
RC IR3
IR transmitter to control the machine via the built-in IR
receiver on the front panel or, instead, via an optional external IR receiver (Model:
C-A35M/IRR-50). The external IR receiver can be located up to 15 meters away
from the machine. This distance can be extended to up to 60 meters when used
with three extension cables (Model: C-A35M/A35F-50).
Before using the external IR receiver, be sure to arrange for your Kramer dealer to
insert the internal IR connection cable (P/N: 505-70434010-S) with the 3.5mm
connector that fits into the REMOTE IR opening on the rear panel. Connect the
external IR receiver to the REMOTE IR 3.5mm connector.
Note that the IR control transmitter can control the
VS-42HDCP
only
when it is set to the P2000 mode.
7.4
Firmware Upgrade
For instructions on upgrading the firmware see “
Upgrading the
VS-42HDCP
Firmware Using the STC Software
”.
i
i
Summary of Contents for VS-42HDCP
Page 2: ......
Page 13: ...10 VS 42HDCP Connecting the VS 42HDCP Figure 3 Connecting to the VS 42HDCP Rear Panel ...
Page 46: ......