Kramer VS-42HDCP, User Manual

Page: 17 / 47

14 VS-42HDCP - Operating the VS-42HDCP 4x2 DVI Matrix Switcher
The input front panel buttons’ status indicates the HDCP state of each input:

HDCP enabled (ON) on an input
– that input button is illuminated

HDCP disabled (OFF) on an input
– that button is not illuminated
3. Press an input button to change its status.
You can press one or more inputs.
4. Once you have changed the status of HDCP on the inputs as desired, press
the EDID to save the changes and exit the HDCP enable/disable mode to
return to normal operation.
Note : If the EDID button is not pressed within about 12 seconds, the device exits
the port HDCP On/Off mode automatically and all changes are lost.
6.6 Locking and Unlocking the Front Panel
To prevent unintended tampering with the unit via the front panel buttons, lock
your VS-42HDCP .
To lock/unlock the VS-42HDCP :

Press and hold the LOCK button on the front panel for about 3 seconds
6.7 Switching Between Protocol 2000 and Protocol 3000
To switch from Protocol 2000 to Protocol 3000 and back again using the
front panel buttons :
1. On the TO OUTPUT 1 row, press input buttons 1 and 3 at the same time.
Protocol 3000 is active.
2. On the TO OUTPUT 1 row, press input buttons 1 and 2 at the same time.
Protocol 2000 is active.
6.8 Acquiring the EDID
You can acquire the EDID from OUT 1 and/or OUT 2 and copy it to any of the four
inputs, or reset to the default EDID. The EDID is acquired at once for all the
inputs, according to the status of the selector buttons.