Kramer VS-42HDCP, User Manual

Page: 18 / 47

VS-42HDCP - Operating the VS-42HDCP 4x2 DVI Matrix Switcher 15
15
To acquire or change the EDID of one or both new output displays :
1. Connect the required acceptor to the output from which you want to acquire
the EDID.
2. Connect the power supply.
3. Press the EDID button and hold it for 3 seconds.
The four buttons that switch to the output from which you are acquiring the
EDID show their current state:

Input buttons that do not illuminate, store the default EDID

Input buttons that flash, store the previously acquired EDID from the
OUT 1 or OUT 2 acceptor
4. For each input, select the output from which it will acquire the EDID, or
deselect it so it will reset to the default EDID value.
For example, to copy the EDID of output 2 to input 3, press the INPUT
SELECTOR button 3 on the TO OUTPUT 2 line.
5. Press the LOCK button.
The LOCK button and the INPUT buttons flash until the EDID is acquired.
Note that while reading the EDID, the displays that are connected to
the OUT 1 and OUT 2 connectors may flicker once or twice.
To reset to the default EDID :
To reset to the default EDID do either of the following:

Disconnect the outputs and repeat the step 2 to 5 above.

Press the input where the default EDID is to be stored to disconnect it from
the output
6.9 Resetting the IP Parameters
This procedure resets only the IP related parameters. All switching and
preset values remain unchanged.
To reset the IP parameters to their default values (see Section
‎
9 ):

Press and hold the ETH Reset button on the rear panel while powering up
the device
i
i