VS-41HDCP - Operating the VS-41HDCP
9
6.2
Controlling via the REMOTE Terminal Block Connector
The contact closure remote control pins operate in a similar way to the INPUT
SELECTOR button. Using the contact closure remote control you can select the
DVI input. To do so, temporarily connect the required input pin (IN 1, IN2, IN 3 or IN
4) on the REMOTE terminal block connector to the GND (Ground) pin, as
Figure 4
illustrates.
!
DO NOT
connect more than one PIN to the GND PIN at the same time.
To select IN 2,
the 2 PIN
to the G PIN
temporarily
connect
To select IN 3,
the 3 PIN
to the G PIN
temporarily
connect
To select IN 1,
temporarily
connect he 1 PIN
to the G PIN
To select IN 4,
the 4 PIN
to the G PIN
temporarily
connect
Figure 4: Connecting the Contact Closure Remote Control PINs
6.3
Controlling the VS-41HDCP
via the ETHERNET Port
You can connect the
VS-41HDCP
via the Ethernet, using a crossover cable (see
Section 6.3.1
) for direct connection to the PC or a straight through cable (see
6.3.2
Section
6.3.1
Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
) for connection via a network hub or network router.
You can connect the Ethernet port of the
VS-41HDCP
to the Ethernet port on your
PC, via a crossover cable with RJ-45 connectors.
i
This type of connection is recommended for identification of the factory
default IP address of the
VS-41HDCP
during the initial configuration.