8
VS-41HDCP - Operating the VS-41HDCP
6
Operating the VS-41HDCP
This section describes how to:
•
Acquire the EDID (see
Section
6.1
•
Control the machine via the REMOTE terminal block connector (see
)
Section 6.2
•
Control the machine via the ETHERNET port (see
)
Section
6.3
•
Control the machine via the Web pages (see
)
Section 6.4
6.1
Setting the EDID
)
You can acquire or change the EDID (see
Section 6.1.1
) or reset the machine to the
default EDID (see
6.1.2
Section
If the connected output (for which EDID has already been acquired) is
disconnected, the EDID button blinks and then ceases blinking when reconnecting
the same output. When a new output is connected the EDID button blinks to
indicate that new EDID information must be acquired.
).
6.1.1
Acquiring / Changing the EDID
You can work with the default EDID or acquire or change an EDID via the
connected output. Use the EDID button to acquire the output EDID information.
To acquire or change the EDID of a new output display:
1. Connect the power supply.
2. Connect the new output display device.
The EDID button blinks.
3. Press the EDID button.
The INPUT buttons blink in sequence until the EDID is acquired.
6.1.2
Resetting the Default EDID
To reset the default EDID, disconnect the output and repeat the steps in
Section
6.1.1
.