Kramer Electronics Ltd.
MV-4X
– Connecting MV-4X
8
Connecting MV-4X
Always switch off the power to each device before connecting it to your
MV-4X
. After
connecting your
MV-4X
, connect its power and then switch on the power to each device.
Figure 3: Connecting to the MV-4X Rear Panel
To connect
MV-4X
as illustrated in the example in
1. Connect up to 4 HDMI sources (for example, Blu-ray players, a work station and set top
box) to the HDMI IN connectors
.
2. Connect the HDMI OUT A connector
to an HDMI acceptor (for example, a display).
3. Connect the HDBT OUT B RJ-45 port
to a Receiver (for example, Kramer
TP-580Rxr
).
4. Connect the AUDIO OUT 5-pin Terminal block connector
to balanced stereo audio
active speakers.
5. Set IR control from the connected receiver to the Blue-ray player that is connected to
HDMI IN 3 (by pointing the Blu-ray IR remote control to the IR receiver):
▪
Connect an IR receiver cable to the
TP-580Rxr
receiver.
▪
Connect an IR emitter cable from the IR OUT RCA connector to the IR receiver on
the Blue-ray player.
6. Connect the RS-232 3-pin terminal block connector to a laptop.
7. Connect the power adapter to
MV-4X
and to the mains electricity (not shown in
11
16
17
12
