Kramer KDS-DEC7, User Manual

Page: 7 / 114

Kramer Electronics Ltd.
KDS-EN7, KDS-DEC7
– Defining KDS-EN7 and KDS-DEC7
4
Defining KDS-EN7 and KDS-DEC7
This section defines KDS-EN7 and KDS-DEC7 .
Defining KDS-EN7
Figure 1: KDS-EN7 4K AVoIP Encoder
# Feature Function
HOST USB Type B Port Connect to a USB host, for example, a PC for KVM/USB support.
LCD Display Use for device configuration such as unique channel/AV stream setting
on encoder and channel tuning on decoder.
Menu
Navigation
Button

Press to return to the previous menu.

Press to move up to the next configuration parameter.

Press to go to the next menu.

Press to move down to the next configuration parameter.
Enter Press to accept changes.
LINK LED See Understanding LED Functionality on page 9 .
NET LED
ON LED
24V/1A DC Connector Connect to the power adapter (purchased separately).
RESET Recessed Button Press and hold for 10 seconds to reset the device to its factory default
values. All LEDs flash.
LAN MEDIA 1G(PoE)
RJ-45 Port Unicast: connect for streaming either directly to a decoder or via LAN.
Multicast: connect to multiple decoders or connect to one decoder to
which multiple decoders are daisy-chained via SERVICE (1G) port.
LAN SERVICE 1G RJ-45
Port Used optionally for physical separation between AV and command
streams to separate LAN for security and reliability purposes.
RS-232 3-pin Terminal
Block Connector Connect to an RS-232 device to use as a Gateway and bi-directional
signal extension (even when no AV signal is extended).
AUDIO IN/OUT 5-pin
Terminal Block Connector Connect to a balanced analog stereo audio source/acceptor.
IR 3.5 Mini Jack Connect to an IR sensor or emitter for bi-directional signal extension
(even when no AV signal is extended). Expected voltage for IR receiver
- (3.3V).
HDMI IN Connector Connect to an HDMI source.
HDMI OUT Connector Connect to an additional KDS-EN7 device to loop the signal, or to a
local acceptor.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15