![background image](http://html1.mh-extra.com/html/kramer/fc-132eth/fc-132eth_user-manual_2001815031.webp)
FC-132ETH - Operating the FC-132ETH Remotely via the Web Pages
27
9.6
Serial Port Settings Page
The Serial Port Settings page allows you to set the parameters that will be used
when the port is switched to an Ethernet port and also allows you to:
Set the following Ethernet parameters for each of the 33 serial ports. These
parameters must be used to address the serial port form and Ethernet host:
Select TCP or UDP
IP port label
TCP keep alive time: 0-3600sec (default 60sec) time internal, after-
which detected idle connection is disconnected
Set the following serial parameters for each serial port. These parameters must
be used when data arrives at the port from an Ethernet connection using the
above-mentioned Ethernet settings:
Parity
Data bits
Baud rates
Stop bits
Note
: When switched to one of the local 1-8 serial inputs, these settings are not
used).
Select whether or not to send replies on the port to the new client