Kozy-World GLD2460R, User Instruction, Page: 20 / 35

20
INSTALLING LOGS
Provided Logs: 7
1. Insert log #3 into slots in
middle grate, and tighten
nuts.
Fig. 20 - Installing Log #2
Fig. 21 - Installing Log #1
Fig. 22 - Installing Log #4 and log #5 Fig. 24- Installing Log #7 Fig. 23 - Installing Log #6
5. Insert the pin on the bottom
of log #6 into the recessed
hole on log #3 and place
the other end on log #1.
6. Insert the pin at the
top of log #7 into the
recessed hole on log #2
and place the other end
onto log #5.
4. Insert log #4, log #5 into
slots in front log bracket
on grate base and tighten
nuts.
3. Insert log #1 into slots in
rear log bracket on grate
base, and tighten nuts.
2. Insert log #2 into slots in
rear log bracket on grate
base, and tighten nuts.
Fig. 19 - Installing Log #3
WARNING: Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in property damage
or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no yellow
flame comes in contact with any log. With the heater set to High, check to see if
yellow flames contact any log. If so, reposition logs according to the log installation
instructions in this manual. Yellow flames
contacting logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Use only logs
supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs
when installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.