15
9.0
FIREPLACE INSERT SETUP
WARNING
Do not operate this fireplace with the glass removed, cracked, or broken. Replacement of the glass frame assembly, #700-006T, should
be done by a licensed or qualified service person.
Do not remove the glass frame assembly when hot.
1. Align the slots on top of the glass frame assembly over the
tabs at the top of the firebox while lowering the bottom of
the glass frame assembly into position. Refer to Figure 9.1,
Glass Frame Assembly Removal and Installation.
2. Pull the spring-loaded latches out and up to secure the
bottom of glass frame to the bottom of the fireplace.
1. Locate (2) spring-loaded latches securing the glass frame
assembly at the bottom of the firebox. Refer to Figure 9.1,
Glass Frame Assembly Removal and Installation.
2. Pull the spring-loaded latches out and down to release the
bottom of the glass frame assembly.
3. Lift glass frame assembly up and off of the (2) tabs located
at the top of the firebox.
Figure 9.1, Glass Frame Assembly Removal and Installation
9.1
Glass Frame Assembly
9.1.1
Remove Glass Frame Assembly
9.1.2
Install Glass Frame Assembly
9.2
Shroud Installation
For shrouds #CK34-2740, #CK34-3044, #CK34-3346, #CK34-
A344, #CK34-CUS, and #CK34-ACUS.
1. Remove the upper hood by lifting up and out of the
mounting flanges.
2. Remove lower louver by lifting the louver out of the slots on
the mounting flanges.
3. Remove the glass assembly.
4. Align the mounting holes on the shroud to the
corresponding mounting nuts on the sides of the insert
metal cabinet.
5. Secure with (4) truss head screws (provided).
6. Reinstall all components previously removed.
Figure 9.2, Upper Hood and Lower Louver
Figure 9.3, Mounting Nut Locations
MOUNTING
NUTS
(2 EACH SIDE)
