Wiring Requirements
SECTION 9
ELECTRICAL INFORMATION
#CLW-50-MV
R.1 October 2021
55
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
9.0 ELECTRICAL INFORMATION
WARNING: Do not use this fireplace if any part has been under water.
Immediately call a qualified service technician to inspect this appliance
and to replace any part of the control system and any gas control which
has been under water.
9.1 Wiring Requirements
CAUTION: Do not connect high voltage (115V) wire to the gas valve.
•
The millivolt gas valve system does not require 110-120 VAC
supply to operate.
•
A wall switch, remote, or thermostat switch must be installed
for main burner operational control using low-voltage wires
(not included).
•
It is optional to disable rocker switch operating the main burner
by disconnecting the wires from the back of the gas valve
•
If the rocker switch wires are not disconnected, the ON/OFF
rocker switch must be in the OFF position for proper operation
of optional controls. If the ON/OFF rocker switch is ON, the main
burner will operate until it is turned OFF by the rocker switch.
The wall switch, remote or thermostat components will not turn
the main burner off if the main burner has been turned on by the
rocker switch.
•
If a wall-mounted ON/OFF control or a thermostat is to be used,
mount it in a convenient location on a wall near the fireplace.
Follow instructions included with assembly.
•
Run the low-voltage wires for the wall switch, remote, or
thermostat from the gas valve to the location of component.
Attach gas valve connectors to the wall switch/thermostat wires,
connect to top and bottom terminals marked TH and TP-TH on gas valve
Thermopile
Thermocouple
Piezo igniter
Pilot
Wire assembly
(not included)
Thermopile
Thermocouple
Piezo igniter
Pilot
ON/OFF
Rocker Switch
FIGURE 9.2
Wiring Schematic with Thermostat or Wall Switch Wiring
FIGURE 9.1
Wiring Schematic with ON/OFF Rocker Switch
