#CW50-SCK Optional Skim Coat Kit
SECTION 4
FACING AND FINISHING
#CLW-50-MV
R.1 October 2021
35
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
4.2 #CW50-SCK Optional Skim Coat Kit
If you plan to apply a skim coat finish across combustible and non-
combustible materials, using 1/2" thick material, you will need to use
the #CW50-SCK Optional Skim Coat Kit so that the non-combustible
material is flush with the finishing flange (edge) of the fireplace.
This kit includes:
(16) self-tapping screws; (2) side panels; (2) top & bottom panels
1. Ensure the hand bend tabs are bent at a 90° angle for required
clearances. This provides 1/4” of the spacing necessary for a flush
mount installation.
2. Install panels. Align the panels with the corners of the
finishing flange.
3. Do not use any screws above the framing when installing the
bottom panel to avoid damaging any of the gas and electrical
components located behind the panel. Refer to
page 34 for maintaining the required areas.
FIGURE 4.8
Installed Panels and Non-Combustible Material
FIGURE 4.7
Panels Installed
FIGURE 4.6
Aligned Corners
FIGURE 4.5
Hand Bend Tab
