Kozi Tradition A1108, Owner'S Manual

Page: 11 / 40

Page 11
(although this installation is permitted, a 3’ (1
m) vertical rise is strongly recommended)
4. Location of the Heater
Before proceeding with the installation, the following sections should be reviewed:
Section 4: Location of the Heater
Section 5: Typical Installation Configurations
Section 6: Venting System
When selecting a location for your new heater consider the following:
a. Clearance to combustibles. d. Power within 5 feet (1.5 m).
b. Sufficient room to service the unit. e. Access for exhaust venting.
c. Access for outside combustion air. f. EVL not exceeding 25 ft. (7.6 m).
d. NOT approved for bedroom installations. See Exhaust Vent Requirements.
5. Typical Installation Configurations
The following figures describe some typical installations. Variations of these are possible.
Common sense, safety and compliance with local codes must be respected in any
variation.
Figure 9. Free standing through the wall
and the roof installation
Figure 8. Free standing through the roof
installation
Figure 6. Free standing through the wall
and up installation
Figure 7 Free standing through the wall
installation
FLOOR
COMBUSTION AIR
INTAKE OR CHECK
VALVE
THIMBLE
TEE WITH
CLEANOUT
END
CAP
VERTICAL
RISER
12"
305mm
minimum
VENT SUPPORTS
AS REQUIRED
FLOOR
COMBUSTION AIR
INTAKE OR CHECK
VALVE
THIMBLE
END
CAP
12"
305mm
minimum
COMBUSTION AIR
INTAKE OR CHECK
VALVE
TEE WITH
CLEANOUT
FLOOR
PIPE MANUFACTURER'S
THIMBLE OR FIRE STOP.
KEEP ATTIC INSULATION
AWAY FROM PIPE.
RAIN CAP
FLASHING
3"
76mm
FLOOR
COMBUSTION AIR
INTAKE OR CHECK
VALVE
THIMBLE
TEE WITH
CLEANOUT
RAIN CAP
FLASHING
3" (76 mm)
CLEARANCE
WALL SUPPORT
BRACKET
PELLET VENT