Kortho 814532, Manual

Page: 31 / 65

OPERATION
H215 AE
Rev.: 10
kortho
Hot Quick Coder-D
6-5
6.3.4 Set time
This parameter is only accessible from the SET TEMP parameter.
Fig. 6.9 SET TIME parameter.
The SET TIME parameter is the desired print time. The print time has a range from 5.0 to 50.0 milli ‐ seconds.
The current parameter value is represented by #.##s. This parameter can be stored as a preset value, refer to
subsection 6.3.1 Preset list.
Press button:
UP ARROW to increase the parameter value.
DOWN ARROW to decrease the parameter value.
LEFT ARROW to shift to the SET TEMP parameter.
RIGHT ARROW longer than two seconds to shift to the FIRMWARE VERSION message.
STOP to return to the STOP MODE MENU and stop printing.
6.3.5 Firmware message
This parameter is only accessible from the SET TIME parameter (press the RIGHT ARROW longer than two
seconds).
Fig. 6.10 FIRMWARE VERSION message.
The FIRMWARE VERSION message shows the printer type and current firmware version. The current
version is represented by V#.#.###.
Press button:
LEFT ARROW to shift to the SET TIME parameter.
RIGHT ARROW to shift to the SET LCD CONTRAST menu.
STOP to return to the STOP MODE MENU and stop printing.
6.3.6 Set LCD contrast
This parameter is only accessible from the FIRMWARE message.
Fig. 6.11 SET LCD CONTRAST menu.
In the SET LCD CONTRAST menu the LCD contrast can be changed.
Press button:
UP ARROW to darken the LCD contrast, keep pressed until the desired contrast is set.
DOWN ARROW to lighten the LCD contrast, keep pressed until the desired contrast is set
LEFT ARROW to shift to the FIRMWARE VERSION message.
RIGHT ARROW to shift to the SET ALARM parameter.
STOP to return to the STOP MODE MENU and stop printing.
SET TIME: #.##s
HP V#.#.###
SET LCD CONTRAST