Kortho 814532, Manual

Page: 25 / 65

INSTALLATION
H215 AE
Rev.: 10
kortho
Hot Quick Coder-D
5-5
4. After 3 seconds the Stop mode menu appears.
Fig. 5.11 STOP MODE menu.
6. Push the down arrow, the printer will make a print stroke and the print head will stay in his “out”
position.
Fig. 5.12 HEAD OUT screen.
5. If present remove the used hotroll from the heating ring.
8. Place the new hotroll in the heating ring, make sure it clicks.
9. Push the up arrow. The text holder slot will return to his home position and the control unit will show
the STOP MODE menu.
CAUTION:
Placing or removing a hotroll in the heating ring while the print head is in his home position can
damage the printer.
Placing a hotroll into the preheat unit can be done without any additional actions.
Note:
By placing a new hotroll into the preheat unit one can make sure that the print process can continue
immediately after placing a new hotroll from that preheat unit. Place a new roll into the preheat
unit in order to make sure that the proces can be repeated the next cycle.
HEAD OUT ###…C
STOP 25…C
i