Kortel Design KLIFF II, User Manual

Page: 39 / 86

Speedbar installation:
The harness is sold with a speedbar kit ready to use, to allow
the installation of a light accelerator if necessary.
Just position the rings, and make a lark's head on the
Dyneema halyard at the back of the back adjustment. The leg
guide ring is already installed.
Speedbar
Speedbar pulley
Speedbar ring passgeway
Speedbar cords
Adjustments pads
The speedbar should not be set too short. The wing must not be in The speedbar should not be set too short. The wing must not be in
the accelerated position without voluntary action of the pilot on the accelerated position without voluntary action of the pilot on
the speedbar. the speedbar.
4
1
1
2
3
4
5
5
39
3
KLIFF II
The speedbar adjustment is done at the level of the
adjustment pads. Optimal adjustment allows you to take
advantage of the entire speed range of the wing, when the
second rung is pushed out with your legs stretched out.
To install the optional speedbar, simply pass the cord through
the pulley located on the side of the harness, then insert it
into the ring located at the front of the thigh.
2
Preparing your harness
Accessories