TRITON Training Guide
73
"So how do I determine which drum sounds (notes) play a specific tone?"
8. On the
Pattern Edit
page, press to highlight the Tone No.:
>00
parameter (lower-right of the display).
Make sure that this parameter is set to
00
(Tone 0) - if not, press the
6
value key, or press the Numeric
key
0
, then
ENTER
to select Tone
00
. This is the
bottom line
in the Step grid
(0)
.
9. Notice that the
Fixed Note No
. for Tone 0 is set to
B2
. That's the kick drum you hear when you trigger
the pattern - it's on the Step grid at steps 1, 7, 13, 19 and 21.
10. Press to highlight Fixed Note No.:
B2
, then press the
5
value key once, to change it to
C3
. Play and hold
a note on the keyboard to hear the new kick drum. You haven't changed the pattern data yet you've only
changed the note number that plays Tone 0 on the Step grid.
11. Hold down the
ENTER
key and press note
B2
, or use the
6
value key to change the kick drum to
B2
.
"This is too cool ! So how do I edit the kick drum steps in the pattern?"
12. Press to highlight Step No.:
> 01
(left side, below the Step grid). Make sure this parameter is set to
01
. If
not, use the
6
value key to set it to
01
. The vertical line on the left of the Step grid indicates the selected
step number. Also make sure that the Tone No. (right side) is set to
00
.
13. Press the
5
value key twice - to move to Step No.:
03
(or use the
DIAL
). The vertical line indicates no
step has been programmed for step number 03.
14. On the Numeric keypad, press
0
. A white dot will appear at step
03
. Play and hold a note on the
keyboard to hear the new kick drum edit for Tone 0.
15. Continue moving to new step numbers along the grid, then enter more tones for Tone No. 0. If you
decide you don't want a tone at a certain step, just move to that step and press
0
, then
ENTER
on the
Numeric keypad. You'll see the tone (white dot) disappear from the Step Grid - press
0
, then
ENTER
on
the Numeric keypad again - to "toggle" the tones on and off.
"What about editing a simple melody line in an arpeggio pattern?"
16. Press the
PROG
key to exit GLOBAL mode, then select Program
A070 Euro 8va Bass
.
17. Press the
GLOBAL
key to enter GLOBAL mode, press the
MENU
key, then press
P6 User Arpeggio
.
18. Press the
Pattern Setup
tab button and check the
Latch
box to latch the pattern.
19. Press the
Pattern Edit
tab button.
20. Turn
ON
the ARPEGGIATOR and play note
C2
(Low-C) on the keyboard to trigger the pattern.
