Wavetable Osc
19
Tip: Fade between modified and original versions of a Wavetable
1.
Set Mode to
A/B
.
2.
Select the same Wavetable for both A and B.
3.
Make sure that B Offset is set to 0.00.
4.
Set Wavetable A Modifier to
None
.
5.
Set Wavetable B Modifier as desired (for instance,
Hard Clip
).
6.
Use
A/B BLEND
to fade between the normal and modified versions.
With
Hard Clip
, this will create a sound similar to a low-pass filter. Try modulating
A/B BLEND
via an Envelope or
LFO! Since Wavetables A and B are phase-locked, you can use this technique to fine-tune the effects of any of the
Modifiers. For example, try using this with any of the
Tilt, Boost,
or
Cut
options.
B (Wavetable B)
(WAVE SELECT)
[List of Wavetables]
This selects the Wavetable for Wave B; it appears only if
Oscillator Mode
is set to
A/B
.
A/B BLEND
then controls the
mix of Wavetables A and B. Pressing
WAVE SELECT
toggles between selecting
Wavetables A
and
B
.
MOD (Wavetable B Modifier)
This selects the Modifier for Wave B; it appears only if
Oscillator Mode
is set to
A/B
. For more information on
Modifiers, see “MOD (Wavetable A Modifier)” on page 18.
Sample Mode
These parameters are shown when
Oscillator Mode
is set to
Sample
.
MS (Multisample)
[List of Multisamples]
Select this parameter and then either turn the
VALUE
knob or press
ENTER
to bring up the Multisample Select
popup.
Channel
[Stereo, Left, Right, n/a]
This applies to stereo Multisamples only; for mono Multisamples, “n/a” is shown. You can choose whether to use the
original
Stereo
signal, or only the
Left
or
Right
channels (in mono).
S. Offset (Start Offset)
[Off, 1st…8th]
In addition to simply starting playback from the beginning, Multisamples may have up to 8 different pre-programmed
alternate starting points, or “Start Offsets.” These skip part of the beginning of the samples, either to make them more
gentle (for percussive sounds) or to make them start more quickly (for sounds with slow attacks). The number of
available offsets will vary depending on the specific Multisample.
If no alternate start points are available, this will show
n/a
.
