Korg Ci-8600, Owner'S Manual, Page: 84 / 112

84
Loading registrations from a floppy
disk
Here’s how to load registrations that were saved on
a floppy disk.
1. Press the [FUNCTION] switch
2. Insert the floppy disk
3. Access the “Func 6/13” page
4. Select the “Registration” radio button
5. Press the “Load” button
6. Select a file
In the “Filename” cell, use the dial or the
[VALUE] switches to select the file that you
wish to load.
7. Press the “Load” button
When you press the “Load” button, the regis-
tration settings will be loaded from floppy disk
into internal memory. If you press the “Cancel”
button, you will return to the “Func 6/13” page
without loading the data.
When you press the “Load” button, the entire content of
the registrations stored in buttons “A1”–”C5" will be
overwritten and lost. If you wish to keep the current
registrations, you must save them on a floppy disk
before loading other registrations.
4. All setup
Settings such as the FUNCTION settings are stored
in internal memory, but can be saved on floppy
disk as well.
If you execute this operation, the settings will be
preserved in internal memory even when the
power is turned off, so that the same settings will
still be in effect when the power is next turned on.
The contents of All Setup can be saved on floppy
disk.
The following items are remembered.
❍ Setting contents
[FUNCTION] switch settings
“Func 1/13” page
Tune
“Func 3/13” page
Pedal Assign
“Func 7/13” page
Sync. Int/Ext
PC/IF Freq, 38.4/31.2
“Func 8/13” page
Prog., ProgBank, Control, AfterTouch, Exclusive
“Func 9/13” page
Keyboard
Upper 1
Low/Upp2
Dr, Perc, Bass, Acc1, Acc2, Acc3
Chord Rx1, Chord Rx2
“Func 11/13” page
User Scale 1–4 settings
“Func 13/13” page
“Popup Time”
[TOUCH] switch setting
The following settings of the [ACC] switch
One finger, Fingered 1, Fingered 2, Split Point
[VOCAL] switch on/off and “Type” settings
To store these settings into internal memory
Here’s how to store All Setup data into internal
memory.
1. Press the [FUNCTION] switch
2. Access the “Func 10/13” page
If the current settings differ from the stored settings,
this page will show a message of “Setup parameter
modified.” In this case, press the “Write” button to
store the settings into internal memory.
If you turn off the power without storing, the
previous settings will reappear when the
power is next turned on.
Never turn off the power while data is being
stored.
MeMO