
61
Song
If the connected mic is brought too close to the Ci-9600/Ci-8600, feedback may
occur. Please use caution.
The following factors may cause feedback when a mic is used; please make adjust-
ments as necessary for best results.
The directional characteristics of the mic; the mic is pointed toward the Ci-9600/Ci-
8600; the mic is too close to the Ci-9600/Ci-8600; settings of the [MIC VOLUME] slider
and [VOCAL EFFECT LEVEL] slider.
If you will not be using the mic, move the [MIC VOLUME] slider and the [VOCAL
EFFECT LEVEL] slider to “0,” and disconnect the mic from the mic jack.
The mic jack is monaural. If you wish to connect a stereo output instrument such as a
synthesizer and play its sounds from the Ci-9600/Ci-8600’s speakers, connect it to the
[INPUT] jacks located on the rear panel of the Ci-9600/Ci-8600.
Using mic effects
1
Press the [VOCAL] switch
When you press the EFFECTS [VOCAL] switch, the “Vocal Effect” page will appear.
The switch indicator will light, and an effect will be applied to the sound from the mic.
2
Select the desired type of effect
Use the dial or the [VALUE] switches to change the “Type” cell.
Type list
This setting can be stored in internal memory by executing the “Write” operation in
the “Func 10/13” page item “Setup,” so that the setting will be applied when the
power is turned on. (
3
Adjust the effect depth
Use the [VOCAL EFFECT LEVEL] slider to adjust the depth of the effect. A setting
of 10 produces the maximum effect.
Depending on the type of effect, increasing the depth may make the mic more
liable to feedback. If this occurs, adjust the [MIC VOLUME] slider and the
[VOCAL EFFECT LEVEL] slider.
To turn off the effect
Press the EFFECTS [VOCAL] switch to make the [VOCAL] switch indicator turn
off.
1.
Garage reverb
Garage-type reverb effect
2.
Hall reverb
Vocal-type reverb effect
3.
Arena reverb
Arena-type reverb effect
4.
reverb
Chorus and reverb effects produced simultaneously
5.
Echo
Echo effect
6.
Funny voice low
A sound one octave below the original sound will be added
7.
Funny voice high
A sound one octave above the original sound will be added
8.
Vibrato
Vibrato effect
9.
Phase
An effect that produces a cyclic “swooshing” tone
10.
Delay S
Short delay
11.
Delay L
Long delay
MeMO
MeMO
Summary of Contents for Ci-8600
Page 1: ...2 E Owner s Manual...